Daystar KJ03006BK Manuel d'utilisateur télécharger pdf

KJ03006 Jeep TJ Front Control Arm Bushing Kit 1997-2001

Installation Instructions

1. Please read the instructions completely and check the Bill of Material before beginning the installation.

2. Raise and support the front of the vehicle with jack stands behind the rear leaf spring perches so that

the tires just touch the ground.

3. Remove one control arm at a time noting its position and how it is installed.

4. Remove the factory rubber bushings by burning out the centers with a suitable propane or acetylene

torch. DO NOT damage the outer shells, as they will be reused.

5. Clean the outer shells with a suitable tool so that they are free and clear of any debris.

6. Using the supplied Daystar Lubrethane, install the corresponding bushing, thrust washer, and steel

sleeve into the control arm sleeve per the figures below. (NOTE: On the axle differential, you may have

to trim the M02410 Thrust Washer so that it will fit into the control arm due to the different models.)

7. Reinstall the control arm from the position in which it was removed and torque to factory specifications.

8. Complete this for the other three control arms.

9. Recheck all bolts and re-torque after 500 miles.

www.DaystarWeb.com

Tech Support Contact Info

Phone: 623.907.0081

Fax: 623.907.0088

841 South 71

Avenue

Phoenix, AZ 85043

Bill of Material

Part No. Description Qty.

M02413 Bushing 4

M02409 Thrust Washer 4

M02414 Bushing 4

M02411 Thrust Washer 2

M02410 Thrust Washer 2

S10091 Steele Sleeve 4

S10092 Steele Sleeve 4

A01133 Daystar Lubrethane 1

Instruction Sheet P10520-01

KJ03006 Jeep TJ Front Control Arm Bushing Kit 1997-2001 Installation Instructions

Pas de commentaire

Daystar KJ03006BK Manuel d'utilisateur