Daystar KF09110-1 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la voiture Daystar KF09110-1. Daystar KF09110-1 User Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 4
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
TOOLS NEEDED BILL OF MATERIALS
Part No. Description Qty
M03876 Front Spacer 2
S11094 Stud extenders 6
S10010 10mm Washer 6
S10292 10mm –1.5 lock nut 6
P11153 Thread lock 1
Description Qty
Floor Jack 1
Jack Stands 2
Lug Wrench 1
10mm wrench 1
17mm wrench 1
20mm wrench 1
21mm wrench 1
Torque wrench 1
Pry Bar 1
17. Install the tire/wheels.
18. Lower off the Jack stands and place back on the ground.
19. Wheel alignment is required.
20. Check all bolts/nuts after 500 miles.
IMPORTANT NOTE: The advertised amount of lift that this kit provides and the thick-
ness of the spacers supplied will not be the same! For example, a 2-1/2” lift may only
have 1-1/2” thick spacers. The reason for the difference between the spacer thickness
and the amount of lift has to do with suspension geometry. There is a ratio involved,
and it is this ratio that determines the thickness of the spacers. Rest assured, installing
the spacer supplied will result in the proper amount of lift out at the wheel.
Instruction Sheet P10597-05
2007 Daystar Products International Inc.
www.Daystarweb.com
Tech Support Contact Info
Phone: 623.907.0081
Fax: 623.907.0088
841 South 71
st
Avenue
KF09111
FRONT SPACER LIFT 2.5”
2004-08 FORD F150 2WD & 4WD
2003-07 FORD EXPEDITION
EASY INSTALL KIT
Vue de la page 0
1 2 3 4

Résumé du contenu

Page 1 - EASY INSTALL KIT

TOOLS NEEDED BILL OF MATERIALS Part No. Description Qty M03876 Front Spacer 2 S11094 Stud extenders 6 S10010 10mm Washer 6 S10292 10mm –1.5 loc

Page 2

Thank you for choosing Daystar Products Daystar recommends a certified technician install this system. In addition to these instruction

Page 3

12. With the ball joint nut installed on the ball joint tighten the upper strut nuts. 13. Reinstall the brake line bracket to the strut tower. Inst

Page 4

5. Separate the upper ball joint from the spindle. Use a ball joint separator or other suitable tool. 6. Remove the 3 upper strut mounting nuts on

Commentaires sur ces manuels

Pas de commentaire