Daystar KG09112 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la voiture Daystar KG09112. Daystar KG09112 User Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 4
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
TOOLS NEEDED
Floor Jack X 1
Jack Stands X 2
Puller Tool X 1
Hand Tools
18mm socket and wrench
BILL OF MATERIALS
P11321 X 2 Torsion Keys
P11339 X 1 Instructions
IMPORTANT: The net amount of ride height increase de-
pends upon the age and use of the vehicle, wheel offset, and
numerous other factors. Stated torsion bar ride height in-
creases are based upon factory specifications. If the torsion
bars were “cranked up” at some point in the past, expect a
corresponding reduction in overall height increase with the
new torsion keys. Note that torsion bars, like any other
spring, are subject to fatigue and sagging over time. Also,
torsion bars have different ratings depending on how the vehi-
cle was equipped from the factory. In some cases, installing
heavier rated bars (which can be purchased from a dealer)
may be the only solution to regaining ride height lost from
adding heavy aftermarket accessories, such as a winch
bumper or snow plow.
NOTE: Various types of puller tools are available, however, due to the
extreme loads present in four-wheel drive suspension systems, we have
found the two-jaw style tool that clamps to the crossmember tends to slip
and damage the crossmember. A C-clamp style puller tool is preferred
and available through tool companies such as OTC and Kent Moore.
WWW.DAYSTARWEB.COM
Instruction Sheet P11339
2007 Daystar Products International Inc.
www.Daystarweb.com
Tech Support Contact Info
Phone: 623.907.0081
Fax: 623.907.0088
841 South 71
st
Avenue
KG09112
1988-06 CHEVY K10-20 6 LUG 4WD
TORSION BAR LEVELING KIT
Vue de la page 0
1 2 3 4

Résumé du contenu

Page 1 - TORSION BAR LEVELING KIT

TOOLS NEEDED Floor Jack X 1 Jack Stands X 2 Puller Tool X 1 Hand Tools 18mm socket and wrench BILL OF MATERIALS P11321 X 2 Torsion Keys P11339 X

Page 2 - Product Use Information

Thank you for choosing Daystar Products Daystar recommends a certified technician install this system . In addition to these instruction , professio

Page 3

9. Using extreme caution, tighten the puller tool enough to take the load off the adjuster bolt. Remove the adjuster bolt and nut block, then unlo

Page 4 - Installation steps

1. Place the vehicle on a level surface. Prior to beginning, record ride height on each side of the vehicle by measur-ing from the center of the s

Commentaires sur ces manuels

Pas de commentaire