Daystar KG09123 Manuel d'utilisateur télécharger pdf

TOOLS NEEDED

Floor Jack X 1

Jack Stands X 2

Puller Tool X 1

Hand Tools

BILL OF MATERIALS

S20612 X 2 Torsion Keys

P20724 X 1 Instructions

S20721 X 2 Shock extenders

IMPORTANT: The net amount of ride height increase de-

pends upon the age and use of the vehicle, wheel offset, and

numerous other factors. Stated torsion bar ride height in-

creases are based upon factory specifications. If the torsion

bars were “cranked up” at some point in the past, expect a

corresponding reduction in overall height increase with the

new torsion keys. Note that torsion bars, like any other

spring, are subject to fatigue and sagging over time. Also,

torsion bars have different ratings depending on how the vehi-

cle was equipped from the factory. In some cases, installing

heavier rated bars (which can be purchased from a dealer)

may be the only solution to regaining ride height lost from

adding heavy aftermarket accessories, such as a winch

bumper or snow plow

NOTE: Various types of puller tools are available, however, due to the

extreme loads present in four-wheel drive suspension systems, we have

found the two-jaw style tool that clamps to the crossmember tends to slip

and damage the crossmember. A C-clamp style puller tool is preferred

and available through tool companies such as OTC and Kent Moore.

WWW.DAYSTARWEB.COM

Instruction Sheet P20724

2007 Daystar Products International Inc.

www.Daystarweb.com

Tech Support Contact Info

Tech@DaystarWeb.com

Phone: 623.907.0081

Fax: 623.907.0088

841 South 71

Avenue

KG09123

2011-12 2500/3500 HD 8 LUG 4WD

TORSION BAR LEVELING KIT

1 2 3 4

Résumé du contenu

Page 1 - TORSION BAR LEVELING KIT

TOOLS NEEDED Floor Jack X 1 Jack Stands X 2 Puller Tool X 1 Hand Tools BILL OF MATERIALS S20612 X 2 Torsion Keys P20724 X 1 Instructions S20721

Page 2 - Product Use Information

Thank you for choosing Daystar Products Daystar recommends a certified technician install this system . In addition to these instruction , professio

Page 3

9. Using extreme caution, tighten the puller tool enough to take the load off the adjuster bolt. Remove the adjuster bolt and nut block, then unlo

Page 4 - Installation steps

1. Place the vehicle on a level surface. Prior to beginning, record ride height on each side of the vehicle by measur-ing from the center of the s

Commentaires sur ces manuels

Pas de commentaire

Daystar KG09123 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la voiture Daystar KG09123. Daystar KG09123 User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Pour la voiture Daystar KG09123